Форум по автобезопасности -
автосигнализации

whitei · 05.12.2022, 09:14

Цитата:

Сообщение от adys

We are getting close.

I turned OFF everything that has something to do with the START/STOP and I managed to make the car to turn on the screen, the dashboard, the dials are sweeping but it shows on dashboard Press pedal break to start the engine.

Now.. I might now where the problem is, but I'm not sure. When I've soldered the wires from the relay, I wasn't sure which one is no. 85 and 86. They are not marked on the relay and if this really matters, this might be the problem.

Also, the bypass is not working. When I left the key into the lock, this is when the dashboard lighted up.
When I placed the key inside the bypass module, I removed the battery, which I understand is the right thing to do, right?

Thank you once again for helping me.

85 and 86 does not matter where they are located, you can swap them ... Set temporarily ch7 as IG1 (stops should be constantly on at startup). Next, try starting with the key in the lock without a battery. If it starts up, then figure out why the key bypass does not work, and then we will correct the channel settings.
ivanov.rm @ mail.ru (I'll answer faster here)

Добавлено через 2 минуты

Цитата:

Сообщение от adys

We are getting close.

I turned OFF everything that has something to do with the START/STOP and I managed to make the car to turn on the screen, the dashboard, the dials are sweeping but it shows on dashboard Press pedal break to start the engine.

Now.. I might now where the problem is, but I'm not sure. When I've soldered the wires from the relay, I wasn't sure which one is no. 85 and 86. They are not marked on the relay and if this really matters, this might be the problem.

Also, the bypass is not working. When I left the key into the lock, this is when the dashboard lighted up.
When I placed the key inside the bypass module, I removed the battery, which I understand is the right thing to do, right?

Thank you once again for helping me.

85 and 86 does not matter where they are located, you can swap them ... Set temporarily ch7 as Bypass (stops should be constantly on at startup). Next, try starting with the key in the lock without a battery. If it starts up, then figure out why the key bypass does not work, and then we will correct the channel settings.
ivanov.rm @ mail.ru (I'll answer faster here)

Добавлено через 12 минут

editing posts not working on forum... ср7bypass
and "bypass for the entire time the engine is running" - enable (like 2.3.1)

Форум по автобезопасности - автосигнализации

Форум по автобезопасности -
автосигнализации